Use of pi-allyltricarbonyliron lactone complexes in the synthesis of taurospongin A: a potent inhibitor of DNA polymerase beta and HIV revers transcriptase

The total synthesis of taurospongin A by two new approaches has been achieved where pi-allyltricarbonyliron lactone complexes have been used to control highly stereoselective additions of the nucleophiles to a carbonyl unit located in the side chain of these complexes.     

Analysis of partially resolved liquid chromatographic peaks using dynamic modeling with the kalman filter

Establishing a calibration model is an important part of any mathematical method for multi-component determination. Use of a calibration model based on single spectra is subject to error, because the model spectrum chosen may not be representative of the response over the full range of the calibration. Alternative calibration models require more time to establish calibration, an these may not be convenient for real-time determinations. A novel calibration method is reported for use with Kalman filters. The method, dynamic modeling, is based on the use of libraries of calibration spectra. The set of used to describe the model at any time is based on component concentrations, estimated for the multi-component mixture, as determined from the Kalman filter, so that several spectra can be used to best describe a varying response. Through application of the dynamic modelingt to simulated and real chromatograms, it is demonstrated that use of the method decreases estimation errors cause by model data mismatches, and that full benefit can be obtained from relatively small libraries.     

Rapid quantitative capillary zone electrophoresis method for monitoring the micro-heterogeneity of an intact recombinant glycoprotein

A simple high-resolution capillary zone electrophoresis (CZE) method capable of rapidly assessing the micro-heterogeneity of a 24 kDa molecular weight glycoprotein, has been developed. Separation is carried out using a bare silica capillary at a pH of 2.5 in a commercially available electrophoresis buffer system composed of triethanolamine and phosphoric acid. Over 30 peaks were detected within a run time of 15 min using a 27 cm capillary and approximately 60 peaks were detected using a 77 cm capillary. Although most of the peaks arise from differences in the oligosaccharide structures present on the one glycosylation site on this molecule, other forms of micro-heterogeneity due to the presence of the nonglycosylated form of this glycoprotein and various types of chemical degradation, e.g., deamidation, are also responsible for the multitude of peaks observed. Although the exact chemical identity of each peak in the resulting electropherogram of this glycoprotein is not known, useful information can be obtained for assessing comparability, stability, and batch consistency. Factors impacting the resolution, precision, accuracy, and robustness of the assay are also discussed along with inherent advantages and limitations associated with measuring the micro-heterogeneity of intact glycoproteins.     

Automated assignment of charge states from resolved isotopic peaks for multiply charged ions

The recent proliferation of electrospray as an ionization method has greatly increased the ability to perform analyses of large biomolecules by using mass spectrometry. The major advantage of electrospray is the ability to produce multiply charged ions, which brings large molecules down to a mass-to-charge ratio range amenable to most instruments. Multiple charging is also a disadvantage because mass (m) becomes ambiguous unless charge (z) can be assigned. This is typically performed with simple algorithms that use multiple peaks of the same m and different z, but these methods are difficult to apply to complex mixtures and not applicable when only one z appears for each m. The use of mass analyzers with higher resolving powers, like the Fourier transform mass spectrometer, allows resolution of isotopic peaks, providing an internal 1-Da mass scale that can be used for unambiguous charge assignment. Manual assignment of charge state from the isotopic peaks is time consuming and becomes inaccurate when either the signal level or resolving power are low. For these cases, computer algorithms based on pattern recognition techniques have been developed to assist in assignment of charge states to isotopic clusters. These routines provide for more rapid analysis with higher accuracy than available manually.     

Efficient transesterification/acylation reactions mediated by N-heterocyclic carbene catalysts

Imidazol-2-ylidenes, a family of N-heterocyclic carbenes (NHC), are efficient catalysts in the transesterification involving numerous esters and alcohols. Low catalyst loadings of aryl- or alkyl-substituted NHC catalysts mediate the acylation of alcohols with enol acetates in short reaction times at room temperature. Commercially available and more difficult to cleave methyl esters react with primary alcohols in the presence of alkyl-substituted NHC to efficiently form the corresponding esters. While primary alcohols are selectively acylated over secondary alcohols with use of enol esters as acylating agents, methyl and ethyl esters can be employed as protective agents for secondary alcohols in the presence of the more active alkyl-substituted NHC catalysts. The NHC-catalyzed transesterification protocol was simplified by generating the imidazol-2-ylidene catalysts in situ.     

胆红素在纳米TiO2膜上的吸附行为研究

采用石英晶体微天平现场技术,研究了胆红素在纳米TiO2表面的吸附动力学行为,并考察了溶液pH、硅烷亲脂性试剂及金属离子修饰的纳米TiO2对胆红素吸附的影响。结果表明,胆红素在纳米TiO2表面的吸附平衡常数K为2·0×106L/mol;由于亲水性纳米TiO2表面的羟基和胆红素分子中的羧基发生作用,胆红素吸附量随溶液pH增大而增大;但经过硅烷试剂亲脂性修饰后,吸附量随pH增大而下降;经过金属离子修饰后,改变了TiO2表面电荷导致吸附量增加,且吸附量随金属离子电荷增加而增加,当金属离子所带电荷相同时,吸附量基本相同。     

Synthetic applications of aryl radical building blocks for cyclisation onto azoles

2-(2-Bromophenyl)ethyl groups have been used as building blocks in radical cyclisation reactions onto azoles to synthesise tri- and tetra-cyclic heterocycles. 2-(2-Bromophenyl)ethyl methanesulfonate was used to alkylate azoles (imidazoles, pyrroles, indoles and pyrazoles) for the synthesis of the radical precursors. Cyclisations of the intermediate aryl radicals yield new 6-membered rings attached to the azoles. The aryl radicals undergo intramolecular homolytic aromatic substitution onto the azole rings. Tributylgermanium hydride has been used with success to replace the toxic and troublesome tributyltin hydride. Initial studies show that the protocol can be used on solid phase resins. The molecular and crystal structures of methyl 5,6-dihydroimidazo[5,1-a]iso-quinoline-1-carboxylate and methyl 5,6-dihydroimidazo[2,1-a]isoquinoline-3-carboxylate were determined by X-ray crystallography.     

Formation and stability of N-heterocyclic carbenes in water: the carbon acid pKa of imidazolium cations in aqueous solution

We report second-order rate constants kDO (M-1 s-1) for exchange for deuterium of the C(2)-proton of a series of simple imidazolium cations to give the corresponding singlet imidazol-2-yl carbenes in D2O at 25 degrees C and I = 1.0 (KCl). Evidence is presented that the reverse protonation of imidazol-2-yl carbenes by solvent water is limited by solvent reorganization and occurs with a rate constant of kHOH = kreorg = 10(11) s-1. The data were used to calculate reliable carbon acid pK(a)s for ionization of imidazolium cations at C(2) to give the corresponding singlet imidazol-2-yl carbenes in water: pKa = 23.8 for the imidazolium cation, pKa = 23.0 for the 1,3-dimethylimidazolium cation, pKa = 21.6 for the 1,3-dimethylbenzimidazolium cation, and pKa = 21.2 for the 1,3-bis-((S)-1-phenylethyl)benzimidazolium cation. The data also provide the thermodynamic driving force for a 1,2-hydrogen shift at a singlet carbene: K12 = 5 x 10(16) for rearrangement of the parent imidazol-2-yl carbene to give neutral imidazole in water at 298 K, which corresponds to a favorable Gibbs free energy change of 23 kcal/mol. We present a simple rationale for the observed substituent effects on the thermodynamic stability of N-heterocyclic carbenes relative to a variety of neutral and cationic derivatives that emphasizes the importance of the choice of reference reaction when assessing the stability of N-heterocyclic carbenes.     

Evaluation of multidimensional (ion-exchange/reversed-phase) protein separations using linear and step gradients in the first dimension

The performance characteristics of multidimensional liquid chromatographic protein separations were evaluated using on-line electrospray mass detection, and a novel workflow for automated LC/MS data processing. Two-dimensional ion exchange/reversed-phase LC separations of Escherichia coli cytosol were conducted using either a continuous linear or discontinuous step gradient in the first dimension. Chromatographic profiles of the top 100 most abundant components were characterized to assess overall separation reproducibility within each mode, and to characterize differences in component distribution between the two modes of operation. Analysis of the resulting data indicates that multidimensional separations of complex protein mixtures can be done reproducibly. Furthermore, under the conditions employed within this study, a linear first dimension gradient was more effective at fractionating the protein mixture, distributing fewer major components to multiple second dimension cycles than an equivalent step gradient. The application of on line mass spectrometry, and automated processing of the resulting data, proved valuable for producing component level analysis of multidimensional protein separations.